Original Blade - Blade Lighting

endcap
	» Endcap dimension is additional to building block dimension. » Endcap uses internal fixing method – no visible fixings.
straight joiner
	» When 2 pieces of extrusion are joined, the join is expressed by a 6mm negative detail. » They are joined by spigots and the negative detail is covered by the internal cover plate.
90 degree bend
	» Bends are made from blank extrusion. » Other angles are available on request. » The bend is joined to the Original Blade system by the use of the straight joiner component. » The angle is expressed by a 6mm negative detail.
suspensions
	» Chrome ceiling cone with wire » Standard suspension lengths are 1000mm, 2000mm, 4000mm and are adjustable on site. » Suspensions can be positioned anywhere along the length of the extrusion but the ceiling cone must be into solid fixing. » Recommended maximum distance between suspensions is 2000mm. » Recommended maximum distance of a suspension from a join is 300mm.
blank extrusion
	» Length to client specification (based on the maximum extrusion length of 3600mm).
cable base & cable
	» Cable base comes in brushed aluminium. » Cable colour: clear. » Cable available in 3, 4, or 5 core (please specify the length). » Specify cable entry position on fitting. If not specified, cable entry will be 100mm from one end.